Upscaling from one uno controlled servo to many - Programming Questions - Arduino Forum

Hello all, I working on an uno controlled servo and toggle switched iris. Simple as one position the iris is open, the other the iris is closed. However, the code (below) I have is for direct control for one servo. I have the adafruit 16 channel/ servo shield and I’m aware that this code wont upscale to the shield. My understanding of what a script is doing when I see it is ok but actually programming from scratch is a problem. I was hoping someone could point me in the direction of a suitable s

Coding multiple switches/servo on Uno - Project Guidance - Arduino Forum

Arduino Servo Motors : 5 Steps (with Pictures) - Instructables

Controlling a Servo, a Stepper and an LED with a single switch - Project Guidance - Arduino Forum

Interfacing Servo to Arduino Uno : 5 Steps (with Pictures) - Instructables

button to set servos position makes the servo irresponsive - Programming Questions - Arduino Forum

Servo Motor controlled via IR Remote Control

Controlling servo using arduino and receiver - General Electronics - Arduino Forum

Controlling 4 Continuous Servo Motors Using Multiple Push Buttons - #21 by groundFungus - Programming Questions - Arduino Forum

Using Multiple Servos with Arduino - Robotics - Arduino Forum

arduino - Controlling Servos with Firmata and Game Control Plus - Stack Overflow

Serial Servo Controller W/Arduino - Control Up to 12 Servos at Once Using the Arduino and a USB Connection : 7 Steps (with Pictures) - Instructables

Control multiple rc servos with multiple buttons - Programming Questions - Arduino Forum